Hardware
Communication parameters
The desktop application currently supports these settings.
| Interface | Parameter | Values |
|---|---|---|
| CAN | Arbitration bitrate | 10k, 20k, 50k, 100k, 125k, 250k, 500k, 800k, 1 Mbit/s |
| CAN FD | Data bitrate | 2, 4, 5, 8 Mbit/s |
| LIN | Baud rate | 2400, 9600, 10417, 19200, 20000 bit/s |
| LIN | Mode | Master, slave |
| UART | Baud rate | 9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600, 1000000 bit/s |
MeLiBu communication parameters: [TBC]
Number of channels: [TBC]
Connector pinout
Device photo: [TBC]
| Pin | Signal | Notes |
|---|---|---|
| [TBC] | CAN_H / CAN_L | |
| [TBC] | LIN | |
| [TBC] | UART TX / RX | |
| [TBC] | 12V output | |
| [TBC] | GND |
Electrical specifications
| Item | Value |
|---|---|
| USB supply voltage and current | [TBC] |
| 12V output capability | [TBC] |
| Bus interface voltage rating | [TBC] |
| Isolation | [TBC] |
| Operating temperature | [TBC] |
| Dimensions and weight | [TBC] |
| Certifications | [TBC] |
Indicators
[TBC]
Wiring notes
- CAN: fit a 120 Ω terminator at each end of the bus and share ground with the device under test. Built-in termination: [TBC]
- LIN: a network can have only one master. LIN needs network power, so check the supply and reference ground.
- UART: cross TX and RX, and match the signal level of the device under test. Supported levels: [TBC]
Safety
- Disconnect power from the device under test before wiring.
- Do not exceed the rated voltage or current of any interface.
- The 12V output is controlled separately and does not follow the LIN channel. Check its state before wiring.